DX DPM Pro v1.1 Envelope/Offset settings cause node latency
-
- KVRAF
- Topic Starter
- 2049 posts since 18 Sep, 2003 from Seattle USA
Hi Blue Cat - If I write an 'envelope' and a 'transformed envelope' the nodes match up in time, same if 'transformed envelope' is reversed. The only setting at this point is decay is 50ms. Everything looks fine.
If I make some settings using the 'amount' and/or 'offset' sliders then the 'transformed envelope' shows a delay compared to the 'envelope'. This doesn't work out for me because the peaks don't match up anymore.
I'm using Sonar4.01
If I make some settings using the 'amount' and/or 'offset' sliders then the 'transformed envelope' shows a delay compared to the 'envelope'. This doesn't work out for me because the peaks don't match up anymore.
I'm using Sonar4.01
-
Blue Cat Audio Blue Cat Audio https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=39981
- KVRAF
- 5971 posts since 8 Sep, 2004 from Paris (France)
You are using the DX version, right?
-
- KVRAF
- Topic Starter
- 2049 posts since 18 Sep, 2003 from Seattle USA
I think it was the DX - hehe but I get them mixed up though you know...maybe I should just take out the VST onebluecatonline wrote:You are using the DX version, right?
-
Blue Cat Audio Blue Cat Audio https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=39981
- KVRAF
- 5971 posts since 8 Sep, 2004 from Paris (France)
For sure VST /Sonar is not the best couple for automation recording. VSt version works perfectly with native VST apps, but it's better to use DX version with native DX apps!