Please forgive what is undoubtedly a very simple question. I am under a deadline and don't have time to hunt manuals etc. to figure it out. I am also new to Kontakt in general.
When I open strummaker(which sounds quite amazing!), and I want to change the panning or the volume, or tuning, add an effect like stereo enhance, how do I do it? I can see how to push "group edit", and I can see the controls, and insert the effect, but when I make any changes in these parameters they have no effect on the output.
I'm missing something very simple! Can anyone help? Thankyou! Darcy
stupid newbie question about group edit
-
- KVRist
- 307 posts since 29 May, 2006
Hi Darcy,
Just hit the "wrench" button to open the edit screen, then the "Group Editor" tab.
Here's the important part:
Make sure that the red "Edit All Groups" button is highlighted.
Now, any changes you make should affect all groups.
Also, when adding effects, make sure that you add them in the Insert Effects (the white and grey area below). You can add them in the Group Insert Effects (green area), but that will create a new instance of the effect for every single group in the instrument, which is not CPU friendly.
TC
Just hit the "wrench" button to open the edit screen, then the "Group Editor" tab.
Here's the important part:
Make sure that the red "Edit All Groups" button is highlighted.
Now, any changes you make should affect all groups.
Also, when adding effects, make sure that you add them in the Insert Effects (the white and grey area below). You can add them in the Group Insert Effects (green area), but that will create a new instance of the effect for every single group in the instrument, which is not CPU friendly.
TC