Hydra / Sound of Power Chord dies out pretty soon
-
- KVRer
- Topic Starter
- 15 posts since 14 Jan, 2024
Hi there. I have the following problem: I have a power chord that should last over 8 bars, but it just stops at around 4. It even does not fade out or so. So I am wondering if there is way to make it last a bit longer or if I have to do that in post, after converting the track to wav?
I did not mess around with the settings and am using the standard values of Hydra.
Studio One 6, Clairvoyant Amp Suite, Shreddage 3 Hydra
Thanks
Eric
I did not mess around with the settings and am using the standard values of Hydra.
Studio One 6, Clairvoyant Amp Suite, Shreddage 3 Hydra
Thanks
Eric
-
- KVRer
- 7 posts since 13 Jul, 2020
..
- KVRAF
- 23115 posts since 7 Jan, 2009 from Croatia
Which exact chord (higher up on the strings or lower strings), which BPM?
It may be that's just the length of the sample. If it doesn't fade out at all for you, sounds like you might have too much gain on the ampsim.
It may be that's just the length of the sample. If it doesn't fade out at all for you, sounds like you might have too much gain on the ampsim.
-
- KVRer
- Topic Starter
- 15 posts since 14 Jan, 2024
Hi. BPM 110, Chords around E-1. I tried four different amp sims so far, but the results were the same. When I find time I'll check the Hydra manual again.
Thanks
Thanks