Pitch-Bend Depth in Built-In Instruments

[The MIDI Guru]

How does one set the desired MIDI pitch-bend depth for the built-in instruments?

I've searched the manual and the forum seeking answers on this, peered at the Inspector panel, and poked at the interface controls. No luck. It appears to be hard-wired to 2 half-steps up and down. Nor can I find any obvious way to increase or decrease it using Note FX.

I don't mean pre-programmed note pitch alterations. I know how to do that in the step sequencer. Nor am I talking about MPE. I mean standard MIDI pitch-bending.

[pikey]

It's in the inspector for the track

[The MIDI Guru]

Thanks. I was expecting it to be in the Inspector for the instrument, not the track, because, you know, in every other MIDI instrument in the world pitch-bend is defined in the preset, not in the track. Oh, well. There's just a lot to learn here.

[Tj Shredder]

It is in the instrument inspector, but in MPE mode Bitwig translates note expressions to PB. Therefor, the track needs first to translate PB into expressions…
Its confusing I know…