apQualizr2 - Linear Phase Dynamics - Expected Behaviour?
Posted: Sun Feb 19, 2023 10:49 pm
This is not necessarily a bug, but I wanted to ask about the behaviour of the dynamics module in linear phase mode. It seems that the detector gets triggered early compared to the other phase modes. For example, setting up the dynamics module to use transient detection and connecting it to the output module to apply a short boost to the entire signal (no filters) works great with mixed, analog, and minimal phase modes; however, when switching to the linear phase mode, the volume envelope seems to be triggered early and the volume boost is applied too late relative to the input signal (thus transients aren't boosted as expected). From what I can discern, this same delay also occurs when using peak and RMS detection modes.
Is this an expected behaviour, or perhaps a consequence of linear phase implementation? Am I totally missing something? This stuff is way above my head, so there's a good chance that I'm just doing something incorrectly or misunderstanding some aspect of this tool. Feel free to set me straight
Any thoughts appreciated!
Is this an expected behaviour, or perhaps a consequence of linear phase implementation? Am I totally missing something? This stuff is way above my head, so there's a good chance that I'm just doing something incorrectly or misunderstanding some aspect of this tool. Feel free to set me straight
Any thoughts appreciated!