this question is aimed mainly to Roger. Is there any drawback about modifying or even remove the wooden side pieces? I was thinking to modify mine to being able to hold an ipad pro 12.9".
Thank you
wooden side pieces mod
-
- KVRist
- Topic Starter
- 137 posts since 12 Aug, 2017 from Switzerland
Hi everyone,
this question is aimed mainly to Roger. Is there any drawback about modifying or even remove the wooden side pieces? I was thinking to modify mine to being able to hold an ipad pro 12.9".
Thank you
this question is aimed mainly to Roger. Is there any drawback about modifying or even remove the wooden side pieces? I was thinking to modify mine to being able to hold an ipad pro 12.9".
Thank you
-
- KVRAF
- 2487 posts since 8 Jun, 2010
- Roger Linn Design
No drawback-- they're purely cosmetic. And if you need replacements, I sell them on my online store.
-
- KVRer
- 12 posts since 19 Aug, 2001 from Scottsdale, AZ, USA
See this thread - viewtopic.php?f=263&t=430897&hilit=ipad+holder
-
- KVRist
- Topic Starter
- 137 posts since 12 Aug, 2017 from Switzerland
@roger: Good to know. Thanks
@Peter: i know it pretty well
i modify it to be printed in 2 pieces and holding an ipad pro on the 128 version. I prepared the file but then i noticed that i didn't have enough filament left. Also i want something detachable so i can still use the linnstrument bag, which i love.
So for now i was thinking of making just a couple of "holes" in the wooden piece:
and then insert 2-3 of these:
In case it would not work then i will go for the full replacement of the wooden part
@Peter: i know it pretty well
i modify it to be printed in 2 pieces and holding an ipad pro on the 128 version. I prepared the file but then i noticed that i didn't have enough filament left. Also i want something detachable so i can still use the linnstrument bag, which i love.So for now i was thinking of making just a couple of "holes" in the wooden piece:
and then insert 2-3 of these:
In case it would not work then i will go for the full replacement of the wooden part
-
- KVRAF
- 8826 posts since 6 Jan, 2017 from Outer Space
That is a brilliant idea...
-
- KVRist
- Topic Starter
- 137 posts since 12 Aug, 2017 from Switzerland
Thank you
But my 3d printer doesn't want to start. I can't connect it, it gives me always an error "access to COM4 denied". But i always did it the same way. Do you guys know something about ports? I have no clue :/
But my 3d printer doesn't want to start. I can't connect it, it gives me always an error "access to COM4 denied". But i always did it the same way. Do you guys know something about ports? I have no clue :/
