Mulab Pitch Bend
- KVRAF
- 12689 posts since 24 Jun, 2008 from Europe
Note that pitch bend is a relative MIDI message, it goes from -100% to +100% and so it depends on the receiving plugin module how many pitch cents that will mean. (an octave is 1200 cents) Are you purely using MUX or are you speaking about VSTs?
- KVRAF
- 12689 posts since 24 Jun, 2008 from Europe
In the oscillator you have a PB (=Pitch Bend) Range control that you can set from -24 to + 24 semitones. So if it's set to 12 then upon receiving a max (=100%) pitch bend message the osc will be bended 1 octave up.
-
fluffy_little_something fluffy_little_something https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=281847
- Banned
- 12880 posts since 5 Jun, 2012
Why can't one select the PitchBend automation parameter underneath the piano roll in the editor and simply draw in pitch bends with the mouse?
I was wondering that when my hardware pitch bender ceased to work properly
I was wondering that when my hardware pitch bender ceased to work properly
- KVRAF
- 12689 posts since 24 Jun, 2008 from Europe
-
fluffy_little_something fluffy_little_something https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=281847
- Banned
- 12880 posts since 5 Jun, 2012
Really? Haven't figured out how, yet. It doesn't seem to accept any of my mouse actions, whether single or double click or whatever...
-
- Banned
- 1256 posts since 22 Feb, 2014
bottom of the piano select pitch bend and double click hold and drag simplefluffy_little_something wrote: ↑Sat Oct 06, 2018 5:05 pm Really? Haven't figured out how, yet. It doesn't seem to accept any of my mouse actions, whether single or double click or whatever...
-
fluffy_little_something fluffy_little_something https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=281847
- Banned
- 12880 posts since 5 Jun, 2012
That doesn't seem to work. I only see a rectangular selection as long as I keep the mouse button pressed and drag the mouse, but when I release the mouse button, nothing has changed.
PS: After many tries I managed to draw in one line now.
PS: After many tries I managed to draw in one line now.
-
- Banned
- 1256 posts since 22 Feb, 2014
Glad you got workingfluffy_little_something wrote: ↑Sat Oct 06, 2018 5:51 pm That doesn't seem to work. I only see a rectangular selection as long as I keep the mouse button pressed and drag the mouse, but when I release the mouse button, nothing has changed.
PS: After many tries I managed to draw in one line now.
- KVRAF
- 12689 posts since 24 Jun, 2008 from Europe
In the very oscillator and sampler editors. If the parameter is not on the front panel of a specific MUX patch, then you need to go into the deep modular editor to open the specific editor. There you'll find the "PB Range" parameter.