Hi there,
when I map a MIDI controller (Modwheel, Aftertouch, etc.) to a parameter in MUX, this works OK. But when I try to change the MIDI controller, this isn't stored anymore. If I reopen the dialogue box, it show the controller again, that was chosen before.
Example: I route the Modwheel to a filter frequency and click OK - works. Then I reopen the dialogue box, change to aftertouch, click OK - nothing happens. Reopen the dialogue box again and it still shows Modwheel.
I'm using MUX (latest release) within Studio One 32 Bit (2.5 and 3.5), Windows 7 64 Bit.
Has anybody else experienced this so far?
Regards, Wilfried
MUX - MIDI mapping issue
- KVRAF
- 12737 posts since 24 Jun, 2008 from Europe
Confirmed issue. Taken note on the M8 work list. Until it's improved you can always edit the controller map via context menu -> Edit MIDI Controller Map. Note that each modular level has its own map and so you need to edit the relevant map (= at the relevant modular level). In MUX VST that's most probably the top MUX level.
- KVRAF
- 12737 posts since 24 Jun, 2008 from Europe