Let's make simple test.
1) Open vst CrusherX Studio and load factory preset #3 Testtone.
We see, that signal level are active on both L and R channels.
2) Then load another factory preset #2 Reset, for make the same "Testtone" preset from scratch.
3) To do this, perform the following: press (disable) "Random" button in DCO section for getting clean tone, and increase Level fader volume in DCO.
Then, in Vapor section press (disable) "L/R" button, and decrease generators amount from 2 to 1.
This is the same config as in Testtone.
But now we see that in level section for some reason signal active in only one "L" channel.
Bug maybe ? (Or i miss something in comparison with Testtone config ?)
Preset #3 "Testtone" - issue ? or..
- KVRAF
- Topic Starter
- 2253 posts since 16 May, 2004 from Soviet Union
Oh my.. Thanks ) Then all ok with this.freq wrote:Hi,
you forgot to move the vapor modulation parameter "Pan" to 50% as a last step
Best
accSone