RMS Normalize
-
- KVRer
- Topic Starter
- 1 posts since 30 Jan, 2018
I have ZynAddSubFx v. 2.2 and 3.0 demo. The instruction shows a control named RMS Normalize, I can not fines this control any were. I want to turn this function off. Is there a way?
- KVRist
- 236 posts since 5 Oct, 2017 from Närförort söder
Without knowing that you had asked the same question, I also posted a question about RMS. And I got an answer, perhaps you have seen it?
To be is to do — Socrates.
To do is to be — Jean-Paul Sartre.
Do be do be do — Frank Sinatra.
To do is to be — Jean-Paul Sartre.
Do be do be do — Frank Sinatra.