Bitwig

thouqht · Post by **thouqht** » Sat Feb 16, 2019 12:36 am

Hi, I feel like this should be obvious but I'm struggling to figure out the right workflow.

I want to create a multi-layered instrument where I can stack multiple layers of synths on top of each other and have them played by one midi input.

I tried voice stacking but it doesn't seem to keep each voice sound intact and doesn't allow me to have full control over the octaves.

What would be the best way to set this up? I want to create a a big thick synth sound (ideally using phase 4 combined with poly synth) that spans a few different octaves and oscillators.

Thanks for any help!

ere2learn · Post by **ere2learn** » Sat Feb 16, 2019 12:58 am

"Instrument Layer" is your friend

thouqht · Post by **thouqht** » Sat Feb 16, 2019 5:03 pm

'Doh - that's perfect. I can't believe I didn't know that was there. Thank you

Quack Quack · Post by **Quack Quack** » Sun Feb 17, 2019 1:18 pm

Add a Multiband FX 3 to each instrument so you can really get the low, mid, and high frequencies you want in the over all sound.

askewd · Post by **askewd** » Sun Feb 17, 2019 2:45 pm

ctrl&g is your friend as well. Will automatically put your selected devices into a container.

Bitwig

KVR Audio

How to layer sounds