Hi, I made a track that used some arpeggiated parts and it worked great in Pigments 1.0 but it sounded different in 1.1, and I've narrowed down the problem. Here's how to reproduce:
1. From Templates select the "Analog triple VCO" preset
2. From the Sequencer page select Arp and keep everything default
3. Hold down a single note. The FIRST step of the arpeggio (the one that goes with the note-on event) will play at a very low volume regardless of the incoming MIDI velocity. It will work fine as long as you hold down the note, but each time you start a new note you get one low-volume step.
(Not very obvious with the 1/16 setting, but change it to 1/8 or 1/4 and it's very obvious. Try looping a single whole note in the DAW, and you'll hear the first note quiet every loop.)
This is clearly a timing issue because I can correct it in the DAW by sliding my notes back a few ms so they start before the 8th-note trigger happens.
I'm using Ableton Live 10, but this is reproducible in the standalone version of Pigments as well. I'm on a Mac with High Sierra.
Pigments: arpeggiator bug in version 1.1
-
- KVRist
- Topic Starter
- 116 posts since 13 Feb, 2006
-
- KVRist
- 74 posts since 2 Dec, 2011 from london
Hi yes an Arturia testers has seen this post and reported it to the test team
Thanks
Thanks
Music producer and engineer for 25 years product tester for Arturia
aka Logicaldream
aka Logicaldream
-
- KVRist
- Topic Starter
- 116 posts since 13 Feb, 2006
thanks!