Toggle loop - does not work ?

[milosh_]

Hi
I am new to TX16Wx.
It is interesting to me and I would like to use it live.
However I can not loop toggle.
In the manual I found that there is toggle mode but I feel it is not working right.
In toggle mode sample starts and repeats forever but when i turn the key second time it does not stop (as it should?)
Maybe I am doing something wrong. Can you help me with that?
cheers

[elcallio]

Setting a group to toggle and ding said toggling works fine for me. Can you share the program you created so I can figure out where you went wrong?

[milosh_]

Thank you! I sent you PM.

[elcallio]

So the problem is that the group is set to both "toggle" and "mono". Effectively this means that while the toggle makes second note-on act like a note-off for the playing voice, the mono state makes the note-off in turn try to find an active note to transition to, finding itself.

I think a reasonable fix is to never allow mono transitions to go from a current playing key to next key with same note value. Should not affect anything else.

Fix will be in upcoming release. Until then, you can simply set the group to poly, and if you need mono behaviour, simply use a choke group instead.

[milosh_]

Thank you!