Modwheel Doesn't Seem to Work with Loop Start/End

Official support for: tx16wx.com
Post Reply New Topic
RELATED
PRODUCTS

Post

I was trying to play around with setting the loop start/end times with mod wheel. Didn't seem to work. I switched over to the pitch-bend just to see. No luck with that either.

Post

Share your program. I'll look at it.
TX16Wx Software Sampler:
http://www.tx16wx.com/

Post

Sorry for the late reply. I'm attaching the program now. Do you need the sound files too, or are you able to get all you need from the program?

I also want to add that I had no problem with Start and End with modwheel, only Loop Start and Loop End.

Thanks!
You do not have the required permissions to view the files attached to this post.

Post

I cannot really tell without the wave files, but I think your problem is that you try to affect Loop End with a positive scale + positive modulator (wheel), but the loop end is so close to wave end that you hit the limit before you really hear it? Try setting the modulation strength to a negative value, and it should move the loop end closer to start.
If this is not the issue, please attach the waves as well and I will look again.
TX16Wx Software Sampler:
http://www.tx16wx.com/

Post

elcallio wrote: Sun May 19, 2019 12:33 pm Try setting the modulation strength to a negative value, and it should move the loop end closer to start.
If this is not the issue, please attach the waves as well and I will look again.
I had forgotten to mention I had tried both positive and negative values. Still no dice. I can't seem to upload the .wavs here as they are apparently too big at 6.2 mb, so here's the google drive link:

https://drive.google.com/drive/folders/ ... sp=sharing

Post

Ah, I see the problem. The modulation scale calculation was off. Weird that it ever seemed ok when I tested it.
Should be correct now. New build is up.
TX16Wx Software Sampler:
http://www.tx16wx.com/

Post Reply

Return to “CWITEC”