I have a load of samples (multisampled instruments and loops / lines) which have glitches at the end where they have not been edited perfectly.
Now, I could load them into an Audio Editor and edit each one to add a Fade in or Fade Out or both, save them, then load them into TX16Wx.
But, it would be much quicker to load them directly into TX16Wx and add the (non-destructive) fades there. The Fade In and Fade out could be added / removed from the context menu (same as Add / Delete loop) and displayed as 2 additional draggable flagged lines. The lower end of the fade lines always follows the Start and End lines.
As in this rough mock-up:
>>> http://i.imgur.com/pz00KUg.png
Related thread:
http://www.kvraudio.com/forum/viewtopic ... 3&t=431515 (for loop slices)
FR: Sample Editor - draggable Fade in and Fade Out
-
- KVRAF
- Topic Starter
- 10309 posts since 2 Sep, 2003 from Surrey, UK
-
- KVRAF
- 2398 posts since 27 May, 2005 from Stockholm
Fade region is already a feature of v3. It is however destructive edits.
TX16Wx Software Sampler:
http://www.tx16wx.com/
http://www.tx16wx.com/