Limiter 6 GE: PCM settings for individual modules?
- KVRAF
- Topic Starter
- 1959 posts since 21 Sep, 2007 from The Infinite Void
It's my understanding that, regardless of the settings of the output limiter, each module acts upon the true-peak level of the signal. Is there a way to get the modules to react to PCM level while using only the output limiter to control for true-peak spikes?
-
- KVRist
- 299 posts since 2 Nov, 2020
The closest you can get to this: use one instance in Low Latency mode with the final limiter disabled, then use a second instance in a normal mode with just the final true peak limiter enabled.
I'm not sure if the modules react to PCM but the clipper aliases a lot in Low Latency if that's anything to go by.
I'm not sure if the modules react to PCM but the clipper aliases a lot in Low Latency if that's anything to go by.
- KVRian
- 1169 posts since 24 Feb, 2012
Interesting request. Some sort of lofi mode, per module?
Fabien from Tokyo Dawn Records
Check out my audio processors over at the Tokyo Dawn Labs!
Check out my audio processors over at the Tokyo Dawn Labs!