Guitars (Strategy/Telematic/etc) stop strumming in Pattern mode

Official support for: acousticsamples.net
Post Reply New Topic
RELATED
PRODUCTS

Post

I don't remember having this problem before but I haven't been using it long so I'm not sure if this is rare, but in Pattern mode the guitars stop strumming or picking after a couple of chords are triggered. I have a 16 bar loop that triggers a different chord every 2 bars. I tried to shorten the note lengths a little bit so they don't touch the next chord but that doesn't matter. It doesn't matter what the pattern is. I have to re-press the key that selects the pattern to get it going again but then it stops. When it does stop, you can hear the faint sustain of the strings (like the end of the string ringing out, but very faint). The faint ringing sound does play with each chord. Could this be a scripting issue?

Ableton Live 10.1b19 // Win 10

Post

Are you sure you're not looping on one bar? Usually sequencers send an all note off signal when it loops.
In any case, there must be something else going on, because it really does not stop after a bar or two, it just loops endlessly.
Image

Post Reply

Return to “AcousticsampleS”