MeldaProduction

alexang · Post by **alexang** » Wed Jan 15, 2020 1:39 pm

Can we please get the following bypass button to be modifiable/assignable with parameters?
I'm trying to make a few envs/lfos in the easy screen that have a dropdown to select where you want to assign it. But it's not possible without this.

jmg8 · Post by **jmg8** » Wed Jan 15, 2020 3:50 pm

Hey

That's actually an invert switch.
You can modulate the values in the slots instead. So if you want to switch off one of the slots, then simply make it 0%

alexang · Post by **alexang** » Thu Jan 16, 2020 9:30 am

Oh sweet. Thanks. Yeah, if the settings I had it was acting as bypass. My bad.

alexang · Post by **alexang** » Sun Jan 19, 2020 5:19 am

The solution if anyone is curious, is to add a Constant modulation into slot 2, that is multiplied to the first. Then select invert on the constant.

This multiplies the env by 0 at 100% depth.

So you can the. Use a switcher/selector set to bank mode, and target the Constant depth. Use value of 100% for off and 0% for on.

This allows you to create a modulator block in Easy screen with a dropdown to choose where it goes to.

MeldaProduction · Post by **MeldaProduction** » Thu Jan 23, 2020 9:42 pm

good solution!

MeldaProduction

KVR Audio

MSF - Can we get PerVoice env bypass switch to be modifiable