KVR Audio

Carpenter · Post by **Carpenter** » Sun Oct 14, 2018 7:25 pm

I'd like to use my Maschine Mikro MK2 as a generic pad controller for Battery. Every time I try this ALL of the pads on my Mikro link themselves to the first cell in Battery only. I can't get the Battery cells spread out to all the pads on Maschine. What am I doing wrong?

zvenx · Post by **zvenx** » Sun Oct 14, 2018 7:35 pm

Don't have my maschine in front of me, but you did switch it to midi mode right?
rsp

Carpenter · Post by **Carpenter** » Sun Oct 14, 2018 8:53 pm

Yep. Sure did.

liv · Post by **liv** » Sun Oct 14, 2018 9:42 pm

Try open controller editor app and load a suitable controller map, or create a new one and map to your liking.

zvenx · Post by **zvenx** » Sun Oct 14, 2018 9:55 pm

I seem to recall having a Battery template (which I think came from NI)... usually the only issues I have had is if it is in the wrong octave, which is easy enough to change.
rsp

Included here, although it is for the original Mk1 Hardware controller.

Using Maschine Hardware As A Generic Pad Controller?