Trouble with loading Wavetables in Fathom (SOLVED)
-
- KVRian
- Topic Starter
- 1451 posts since 2 Mar, 2005
I'm trying to figure out how to load a regular wavetable in Fathom. I just purchased it a few weeks ago and only have had a minimal amount of time to really dive into it. I have searched the manual, but it doesn't seem to list the procedure (unless Ive missed it).
These have been my steps so far:
-Load a wavetable oscillator
-Click On Parameters
-Click Browser
-Click Waves Folder
-Click Wave Tables
-Select My Wavetable that I would like to use
-Click Load
The browser screen closes. I select my Oscillator again (this is a long process btw. In other synths I can just select a folder & load it), Fathom brings up the parameters screen again, but the factory wavetable is still there.
Can anyone let me know what I'm doing wrong, please?
These have been my steps so far:
-Load a wavetable oscillator
-Click On Parameters
-Click Browser
-Click Waves Folder
-Click Wave Tables
-Select My Wavetable that I would like to use
-Click Load
The browser screen closes. I select my Oscillator again (this is a long process btw. In other synths I can just select a folder & load it), Fathom brings up the parameters screen again, but the factory wavetable is still there.
Can anyone let me know what I'm doing wrong, please?
Last edited by Saukar30 on Mon Oct 22, 2018 11:53 pm, edited 1 time in total.
I read more than post = I listen more than I talk
-
- KVRAF
- 1577 posts since 8 Jan, 2003 from Edinburgh
- make sure the "Wave Index" setting is on 1.00 (I think you need to do this)Saukar30 wrote: ↑Mon Oct 22, 2018 6:50 pm I'm trying to figure out how to load a regular wavetable in Fathom. I just purchased it a few weeks ago and only have had a minimal amount of time to really dive into it. I have searched the manual, but it doesn't seem to list the procedure (unless Ive missed it).
These have been my steps so far:
-Load a wavetable oscillator
-Click On Parameters
- click on "File" (over and down one from the Parameters button)
- Click on "load table" (under the "file" button)-Click Waves Folder
-Click Wave Tables
-Select My Wavetable that I would like to use
- click "close"
If you click on the wavetable oscillator - you'll see the new shapes.
That was for the Left side - you can do the same for the Right side.
Use the "amount" control to go between them.
NOTE: I do not know what I'm doing with this - but I puzzled over it last week myself
I'm way out of my depth too
John Braner
http://johnbraner.bandcamp.com
http://www.soundclick.com/johnbraner
and all the major streaming/download sites.
http://johnbraner.bandcamp.com
http://www.soundclick.com/johnbraner
and all the major streaming/download sites.
-
- KVRian
- Topic Starter
- 1451 posts since 2 Mar, 2005
Load Table... ahh! Thats What it was. Thanks Jbraner! I swear that was driving me insane.
I read more than post = I listen more than I talk
-
- KVRAF
- 1577 posts since 8 Jan, 2003 from Edinburgh
I did the same as you (click "load") for a while too
John Braner
http://johnbraner.bandcamp.com
http://www.soundclick.com/johnbraner
and all the major streaming/download sites.
http://johnbraner.bandcamp.com
http://www.soundclick.com/johnbraner
and all the major streaming/download sites.