How set Amp or Filter envelope in u-he Diva
-
- KVRist
- Topic Starter
- 116 posts since 3 Nov, 2013
Hi, I'm new with synth and Diva. I try to set a Filter envelope instead of AMP envelope. In the right part of diva, there's 2 envelope. The first on top work with AMP envelope but the other just below dosent seem to work with Filter envelope.
How can I set the envelope to working with AMP or Filter?
Thanks
How can I set the envelope to working with AMP or Filter?
Thanks
- KVRAF
- 3897 posts since 28 Jan, 2011 from MEXICO
Did you select envelope2 as modulation source for the cutoff?
Check the manual to see the general operation of the synth.
Check the manual to see the general operation of the synth.
dedication to flying
-
- KVRian
- 702 posts since 19 Mar, 2014 from Denver, CO
Make sure to turn up the envelope modulation depth on the filter - how to do so is dependent on the filter being used.
-
- KVRist
- Topic Starter
- 116 posts since 3 Nov, 2013
This is what I try to figure it out The synth I use before had already 2 separate envelope for AMP and Filter. Maybe you have a tutorial from another synth and I can use for Diva?
Cheers
Cheers
-
- KVRAF
- 3496 posts since 9 Oct, 2004 from Poland
On this screenie the "ENV 2" knob is just on bottom left of the CUTOFF knob.
You can turn it clockwise for positive values and counterclockwise for negative.
On a Minimoog the knob would be called "amount of contour".
[====[\\\\\\\\]>------,
Ay caramba !
Ay caramba !
-
- KVRist
- Topic Starter
- 116 posts since 3 Nov, 2013
Mutant: thanks for sharing. It will save me time. Now everything start to make sense how this knob are reliate together.
Cheers
Cheers